Mercedes Benz — Eliminate/put in twin clutch transmission (Portion one) SLS AMG



ten,13,The twin clutch transmission |of the SLS is compact …||
13,16,… and sits among the generate shafts|for the rear wheels.||
seventeen,twenty,The transmission has a transaxle design and style.|||
21,24,The twin clutch transmission shifts gears|with no interruption of tractive power.||
25,29,In guide mode, gear adjustments |can be created in 100 msec.||
30,38,Right before eliminating the transmission, |resolve the automobile adequately in area |on the automobile elevate.|
39,42,Elevate the automobile.|||
forty three,fifty three,Eliminate the rear underfloor |paneling and reinforcement.||
fifty four,66,Detach the controller device|for the parking brake.||
seventy two,seventy seven,Unhook the right-hand brake cable.|||
seventy eight,83,The left-hand brake cable and Bowden cable|for crisis launch stay set up.||
84,ninety,Correct the controller device in area at |an appropriate point to protected it.||
ninety one,ninety seven,Also take out the rear reinforcement.|||
ninety eight,100,Also take out the exhaust procedure.|||
one hundred and one,one hundred ten,To do so, unscrew the bolts shown listed here.|||
113,a hundred and twenty,See the WIS doc shown |listed here for torque information and facts.||
142,148,Eliminate the corresponding bolts |on the left-hand automobile facet.||
149,153,Eliminate the exhaust procedure |with the help of an assistant.||
158,163,Eliminate the rear provider.|||
164,167,The transmission is now uncovered.|The generate shaft can be eliminated.||
168,a hundred and seventy,To do so, take out 6 bolts on the flange.|||
171,one hundred eighty,Through installation, replace all bolts|and notice the present-day torques.||
182,188,Transform the rear wheel in order to |get to all bolts of the flange.||
197,200,Area the shaft down |on a padded surface area.||
201,203,Repeat the course of action on the |other facet of the automobile.||
210,221,Detach the left floor strap |on the transmission.||
222,228,Swap the bolt through |subsequent installation.||
231,235,In excess of the floor strap, disconnect |the connector for the clutch module |controller device.|
236,241,Also disconnect the higher connector |for the change module controller device.||
244,255,At the rear conclusion of the torque tube, |unscrew the heat shielding.||
259,267,Area an oil receptacle |less than the transmission.||
268,276,Initial unscrew the bracket for the |oil line of the hydraulic circuit.||
280,285,Open up the link of the |oil line on the transmission.||
286,290,Be aware: Just take care!|The oil could be scorching.||
299,302,Pull the line downwards a bit.|||
303,307,Enable the hydraulic oil to drip out.|||
316,328,Seal the strains and threaded |holes with halt plugs.||
332,350,At the rear of the transmission, disconnect|the oil strains for cooling the gear established circuit.||
352,355,Protected connections with plugs.|||
356,365,Pull out temperature sensor.|||


Post time: Nov-10-2016